KTM 250/ 300/ 380 SX,MXC,EXC ENGINE REPAIR MANUAL
download Repair manual KTM 250 / 300 / 380 Art No 3206004 -E 2-2C main jet jet needle jet needle air control screw idle adjusting screw idle jet throttle valve Idling range A Operation with closed...
View ArticleYAMAHA RAPTOR 350 Removing stock carburetor and cables
download remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable (s) will need too be routed the same. 3....
View ArticleHOVELHEAD & IRONHEADXL 42mm Mikuni Carburetor And Manifold Kit INSTALLATION...
download THROTTLE CABLE ADJUSTMENT A) Rotate the throttle grip to the full open position, look into the throttle bore and see if the throttle valve (slide) opens completely. If the throttle valve does...
View ArticleTuning the HSR42/ 45 Carburetor
download your Mikuni HSR is fitted with the tuning parts we found to work with the great majority of engine performance modifications. However, the large number of differing exhaust systems and cams...
View ArticleHSR Carburetor Total Kits Installation And Tuning Manual
download 1. Disconnect the battery ground wire from the battery. 2. Turn the fuel petcock to the “OFF” position. 3. Elevate the rear of the fuel tank for better access to the carburetor area. 4. Remove...
View ArticleHARLEY-DAVIDSON 5 Speed Transmissions 1984 – 1999 EVO / 5 Speed & 1999 – 2006...
download Remove Original Parts From Vehicle. 2.1 Obtain a small tube of Loctite® #262 (red) for use later. 2.2 Drain the transmission oil. 2.3 Remove the clutch adjustment cover (left side). 2.4 Remove...
View ArticleHARLEY-DAVIDSON 1984 – 1999 Evo/ 5-Speed & 1999 – 2004 Twin Cam Transmissions...
download Illustrated Parts List Main Shaft Gear (Small Gear) (1) Special Tools (1 set): • 3/4″ Socket Adapter • Ring-Seat Tool • Spring Tapered Split Ring (2) Counter Shaft Gear (Large Gear) (1) Trap...
View ArticleHARLEY DAVIDSON BIG TWIN SPIGET MOUNT CARBURETOR INSTALLATION MANUAL
download A. BEFORE INSTALLATION OF YOUR NEW ZENITH CARBURETOR, NSPECT THE RUBBER MANIFOLD SEAL FOR NICKS,CRACKS, OR DEBRIS. APPLYING A LIGHT FILM OF PETROLEUM BASED LUBRICANT AROUND THE INSIDE LIP OF...
View ArticleHSR Carburetor Total Kits Installation Instructions
download Intake Manifold: 1. Install MAP sensor in Mikuni manifold (Twin Cam only). 2. Attach the Mikuni manifold to the engine. Align the manifold before tightening the bolts. The flange surface of...
View ArticleKTM 60 SX / 65 SX REPAIR MANUAL ENGINE
download Carburetor adjustment Basic information about the original carburetor setting The original carburetor setting was adapted for an altitude of approx. 500 meters (1600 ft.) above sea level, and...
View Article
